GPS and Cell Phone Signal Jammer with Car Charger (Radius Range 10-60 meters)
- Total Transmission Output: 10 Wat
Isolating Signal Bandwidth
- GSM900: 925-960Mhz
- GSM1800: 1805-1880Mhz
- 3G: 2110-2170Mhz
- GPS: 1500-1600MHz
- Typical Radius Range: 10-60 meters
- Antenna Interface: SMA
- Four SMA connectors which are used to connect with anternna (CDMA GSM/DCS PHS 3G ).One Adaptor connector
- Power Source: AC 110-240V and DC12-36V
- Dimension: 455*240*85mm (L x W x D)
How to install Antenna and turn on the Device?
To install the antennas, please try to screw the antennas tightly to the corresponding position on the device according to the length remark on the device and antennas The antenna connectors of Output power and working instruction LED on the Cover.Longer Green,Yellow,Bule,Red Dot connect with antenna which are identified by CDMA GSM,DCS PHS,3G as the indication accordantly, will be ON when the Power SW placed, Power LED shows green,and then the machine begins to work.
- While it is working , the surface temperature is about 45 ℃. It is normal. However , if it is higher than 45 ℃, it is abnormal . Please put the power SW to OFF immediately and try to contact your local distributor or agent .
- The shielding range of the device will be determined by the local signal strength . In different situation, it will be with different performance.
- Please try to put the device in a higher position while it is working .It will be better. The suggested height is about 2M. To avoid the loss of function of the device, please try to avoid the device placed on or the metal materials.
- Do not put the device near computers, notebook computers, televisions, stereos, radios and so on , in order not to make some interference for these equipments.
- Do not turn on the power before the antennas is installed, If the antenna is not properly installed in accordance with the manuals, the shielding range will be not so good. make sure the correct installation before turn on the power.
Fans and Heatsink chip:
To keep the device working with high efficiency. We design two fans to keep heat dissipation. (Fans supply 12V). One Fan is used to keep the heat in, the other one to make the heat out .Therefore , the temperature inside the device will be approximately equal to the outside temperature.Moreover, Heatsink chip ,by taking advantage of complete heat dissipation, make the machine work more stablely
- You can install this device in different car model. It works supplied with 12V inside the car. To make it more user friendly ,We provide the car adaptor with 3M cables. It also can be used in AC 110-240V for indoor purpose.It can be used globally. See the attached pictures.
- This product can be used in any place where mobile phones are prohibited to be used. Vehicle, Meeting Room, Oil and Gas Storage Facilities, Oil and Gas Fields, Hospitals, Theatres, Recording Studios, Banks, Contract Tendering Rooms, Churches, Conference Rooms, Classrooms, Testing Facilities, Security Services, Military Units, Secret Services, News Conference Rooms, Libraries, Museums, Prisons, Courts, Border Patrol and Drug Enforcement,Customs,Houses.
- Remote Control
- Power Supply
- Mounting Screws
- Mounting Bracket
- Band Specific Antennas x4
- 1 x English User Manual (If you need, we will send the scan file via email, it will avoid some possible custom issue)
Write a review
Note: HTML is not translated!
Rating: Bad Good
Enter the code in the box below: